Nostalgia Products CCM510 Manual De La Instrucción página 10

Assembly of Wheels
1. Slide one #5 Flat Washer onto Axle Bolt (F) and insert Axle Bolt (F) into Wheel (G).
2. Put on one #6 Flat Washer. Insert Axle Bolt (F) with Wheel (G) into Base Support (I).
3. Add a second #6 Flat Washer and #7 Nut Cap. Use Wrench (H) to tighten the #7 Nut Cap.
4. Repeat steps to attach second Wheel (G) onto the other side of the Base Support (I).
(#5)
Flat
Washer
(F)
Axle
Bolt
Locking Main Unit to Storage Compartment
Place the Main Unit (A) onto the Storage Compartment (B) so that the two side
holes match up. Lock by tightening the Lock Screws as shown below:
Attaching Rim to Bowl
To attach (C) Rim and Bowl, insert three #8 Screws in pre-drilled holes.
(#6)
Flat
Washers
(#7)
Nut
Cap
(G)
Wheel
(I)
Base
Support
8