Sauder 418646 Manual De Instrucciones página 10

Step 4
Separate the EXTENSION SLIDES (MM) from the
å
EXTENSION RAILS (LL) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten an EXTENSION RAIL (LL) to each END (A and B)
å
and UPRIGHT (C and D). Use eight GOLD 5/16" FLAT
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
Hole
Open end
Page 10
MM
Pull down on the blue lever and pull the SLIDE from the RAIL.
D
B
LL
C
Open end
GOLD 5/16" FLAT HEAD SCREW
Open end
LL
LL
418646
3S
(8 used in this step)
LL
Open end
LL
A
www.sauder.com/services