Sauder 418646 Manual De Instrucciones página 21

Step 15
1
D87
M
Groove
Insert the FILE DRAWER SIDES (D87 and D88)
å
at an angle into the slot at each end of the FILE
DRAWER FRONT (M).
3
Fasten the FILE DRAWER BACK (D78) to the FILE DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the LARGE DRAWER BOTTOM (D708) inserts into the groove of the FILE DRAWER BACK (D78).
å
Repeat this step for the other drawers. The upper drawer will use the UPPER DRAWER FRONT (R), UPPER DRAWER
å
SIDES (D132 and D138), UPPER DRAWER BACK (D77), and DRAWER BOTTOM (D707). The middle drawer will use the MIDDLE
DRAWER FRONT (W), MIDDLE DRAWER SIDES (D10 and D11), DRAWER BACK (D86), and DRAWER BOTTOM (D707).
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
D78
D87
D708
VIEW THE T-LOCK BOX VIDEO
2
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D708) into the
å
grooves in the FILE DRAWER SIDES (D87 and D88) and
FILE DRAWER FRONT (M).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
418646
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D708
D88
M
30S
(16 used in this step)
Page 21