Setup; Indication Of The Switching Status; Simulation; Function Table - SICK LFV200 Manual De Instrucciones

Ocultar thumbs Ver también para LFV200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Max.
2
1
3
4
-
+
L
C/Q
L
Abb. 31: Wiring plan (housing), IO-Link with PNP
switching output, M12 x 1 plug connection
1
L+ voltage supply
2
Max. level detection
3
L- voltage supply
4
Min. level detection/IO-Link communication
5

Setup

5.1
Indication of the switching
status
The switching status of the electronics can be
checked via the signal lamp integrated in the
upper part of the housing.
5.2

Simulation

The LFV200 has an integrated function for
simulation of the output signal which can be ac-
tivated magnetically. Please proceed as follows:
Hold the test magnet (accessory) against
the circle symbol with the label "TEST" on
the instrument housing
Abb. 32: Simulation of the output signal
The test magnet changes the current switching
condition of the instrument. You can check the
LFV200 • IO-Link
Min.
2
1
3
4
R
L
-
+
L
L
change on the signal lamp. Please note that
all connected device are activated during the
simulation.
Caution:
It is absolutely necessary that you remo-
ve the test magnet from the instrument
housing after the simulation.
5.3

Function table

The following table provides an overview of
the switching conditions depending on the set
mode and the level.
Level
Swit-
ching
status
Mode
closed
max.
Mode
open
max.
Mode
closed
min.
Mode
open
min.
Fault
any
open
6

Maintenance

6.1
Maintenance
If the device is used properly, no special mainte-
nance is required in normal operation.
6.2

Rectify faults

Observe the signal lamp. Often the reason for
the fault can be detected.
5 Setup
Control
Con-
Con-
lamp
trol
trol
lamp
lamp
Yellow
- co-
Green
Red -
verage
- vol-
fault
tage
signal
indica-
tion
any
15

Publicidad

Tabla de contenido
loading

Tabla de contenido