Miele HS18 Instrucciones De Uso página 57

Ocultar thumbs Ver también para HS18:
Tabla de contenido

Publicidad

The rechargeable battery status indic-
ator lights up in the control field. The ro-
bot vacuum cleaner will switch to
standby after approx. 60 seconds. The
robot vacuum cleaner is reactivated by
pressing any button on the remote con-
trol or one of the sensors in the control
field.
Connecting the base station
(Fig. 06–09)
Observe the instructions regarding the
handling of the base station and the
power supply unit found in the "Safety
notes and warnings" section at the be-
ginning of these operating instruc-
tions.
 Place the base station on a level sur-
face against a free wall within easy
access of a power socket. Ensure
that there is an obstacle-free distance
of at least 1.5 m in front and 0.5 m to
the right and left of the base sta-
tion (Fig. 06).
 Insert the plug of the supplied power
supply unit into the socket at the
back of the base station. You can
wind excess cable around the cable
rewind. Guide the cable through one
of the two cable guides (Fig. 07).
 Insert the country-specific power ad-
apter into the power supply unit until
it audibly engages and then plug it
into the selected power socket
(Fig. 08).
An adhesive holder is included to per-
manently fix the base station to the
floor (Fig. 09).
 Insert the adhesive holder into the re-
cess provided on the underside of the
base station until the adhesive holder
clicks into place.
 Remove the blue protective foil from
the adhesive strips.
 Place the base station in its chosen
location and press down firmly on the
base station.
You can remove the base station at
any time; the adhesive holder remains
on the floor.
If you want to remove the adhesive
holder from the floor, pull on the two
pulling-off devices.
Charging the battery (Fig. 10)
The rechargeable battery is supplied
not fully charged. Before using for the
first time, it must be fully charged while
the robot vacuum cleaner is switched
on (switch I/0 to I).
The battery can also be charged when
the robot vacuum cleaner is switched
off (switch I/0 to 0). In this case, the
vacuum cleaner indicators will not re-
act.
 Connect the robot vacuum cleaner
correctly to the charging contacts on
the connected base station.
As the rechargeable battery charges,
the status indicator flashes in the con-
trol field.
The charging process takes up to
3 hours for the Scout RX3 and up to
4 hours for the Scout RX3 Runner and
Scout RX3 Home Vision HD.
You can then vacuum for up to one
en
57

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Scout rx3

Tabla de contenido