Vacuuming Manually; Interrupting Vacuuming; Manual Navigation (Without Vacuuming) - Miele HS18 Instrucciones De Uso

en

Vacuuming manually

You can use the direction buttons on
the remote control to vacuum a particu-
lar area of the room.
 While the robot vacuum cleaner is va-
cuuming, press and hold one of the
direction buttons.
The robot vacuum cleaner will turn in
the desired direction until you let go of
the direction button.
 Press and hold the + direction button.
The robot vacuum cleaner will travel in
the desired direction and continue to
vacuum.
 Press the  button on the remote
control or the  sensor in the control
field.
The original vacuuming process will
continue running.

Interrupting vacuuming

60
 Press the  button on the remote
control or the  sensor control in the
control field.
The robot vacuum cleaner stops.
Press the button or the sensor control
again to continue vacuuming.
If you lift the robot vacuum cleaner off
the floor during a pause and then place
it down somewhere else, rLOC will ap-
pear in the display when you activate it
again. The robot vacuum cleaner will
turn around and compare its new loca-
tion with its saved map data.
If the data is compatible, the robot va-
cuum cleaner will start cleaning and not
go over surfaces that have already been
cleaned.
If the data is not compatible, the robot
vacuum cleaner will not move.
rLOC in the display can only be can-
celled by pressing the  button or the
 sensor control several times.
Manual navigation (without vacuum-
ing)
You can use the direction buttons on
the remote control to direct the robot
vacuum cleaner to a specific area of the
room.
 Press and hold one of the direction
buttons.
The robot vacuum cleaner will travel in
the desired direction without vacuum-
ing.