Andis MBG-5 Instrucciones De Uso Y Cuidado página 8

CHANGING THE BLADE DRIVE ASSEMBLY
If your clipper blades no longer cut properly (be sure to try more than one blade,
since the blade currently being used may be dull), it could be that your blade drive
assembly needs replacement.
TO CHANGE THE BLADE DRIVE ASSEMBLY:
1. Remove blade set (Figure H).
2. Remove drive cap (Figure M).
3. Remove blade drive mounting screws (Figure N).
4. NOTE: Before removing blade drive assembly, note the way it is positioned (this will
help you in reassembly). Remove blade drive assembly (Figure O).
5. Drive bearing should be at its lowest position, if not, move it with your finger to
lowest position (Figures P & Q).
6. Put on new drive assembly, align screw holes and press down (Figure O).
7. Reassemble blade drive by mounting screws (Figure N).
8. Replace drive cap (Figure M).
9. Replace blade (Figure J).
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper/trimmer become dull after repeated use, it is
advised to purchase a new set of blades available through your Andis supplier. Some
blade sets can be resharpened - contact your Andis supplier or the Andis Company
for information on resharpening. If you wish your clipper/trimmer to be serviced as
well, contact your Andis supplier. If you have a problem contacting your Andis supplier
contact the Andis Company customer service department 1-262-884-2600 (USA) or
email at info@andisco.com. To find an Andis authorized service station near you
log on to www.andis.com or contact our customer service department by phone
at 1-262-884-2600 (USA), or by email at info@andisco.com.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for environmental safe
recycling.
CAUTION: Never handle your Andis clipper while you are operating a water
faucet and never hold your clipper under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. ANDIS COMPANY will
not be responsible in case of injury due to this carelessness.
8