Andis MBG-5 Instrucciones De Uso Y Cuidado página 4

10. To disconnect turn control to "Off" then
remove plug from outlet.
11. WARNING: During use, do not place or leave
appliance where it may be (1) damaged by an
animal or (2) exposed to the weather.
12. WARNING: Cutting blades may become hot
after prolonged use. Oil blades frequently.
13. Keep the appliance dry.
14. Cleaning and user maintenance shall not be made
by children without supervision.
15. This appliance is intended for trimming purposes only.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
Before starting your clipper, remove blade guard (some models may not have a blade
guard). Plug cord into electrical outlet, operate at rated current and cycle as noted on
unit. After using your Andis clipper, rewrap cord and store in a safe place.
UNIVERSAL AC/DC POWER ADAPTER
The unit is equipped with a universal AC/DC power adapter (Figure A) Interchangeable
input plugs are included for use in most countries around the world (Figures B-D).
INSERTING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. Insert tabs on top of plug into slots on power adapter (Figure E).
3. Push lower half of plug towards power adapter until it snaps into place.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. Push up on tab on bottom of plug until plug releases from adapter.
MBG-4 ONLY (1-SPEED OPERATION)
To start clipper, move switch button to "1" position; to stop, move switch button back
to original position.
MBG-5 ONLY (2-SPEED OPERATION)
To start clipper, move switch to either normal or high speed setting (Figure F). Use the
normal setting (switch in lowest position) for most cutting needs. Use the high speed
setting (switch in highest position) for cutting through heavy hair. To stop clipper,
move switch back to original (center) position.
4