Publicidad
3
ASSEMBLE BRACKETS.
Assemble the base brackets and arm brackets
in the chosen orientation (refer to step 1 for
screws as shown for each bracket assembly. Tighten
NOTE: Example orientation shown is of the base
down with the arms side mounted and angled down.
This is best suited to mounting long Light Bars.
4
Platform and HD Bar
use M6 slot nuts.
INSERT MOUNTING HARDWARE
4
a
Insert four M6 slot nuts into the platform channel
where you want to mount your light accessory.
Refer to step 8 for positioning information.
HD BARS
Instruction #28-13-336 Rev.3 - Page 3 of 13
SELECT CORRECT MOUNTING HARDWARE.
Select the correct mounting hardware option as shown below.
NOTE: Light
brackets can
4 sides of the
Platform.
two M6 slot nuts into
your HD Bar where you
want to mount your light
accessory. Refer to step 8
for positioning information.
4X
4
INSERT MOUNTING HARDWARE
4
a
- LockNLoad Crossbars
Insert four M6 spring nuts into the crossbar channel
where you want to mount your light accessory. Push
the spring nuts down into the crossbar channel and
twist to lock them into place as pictured. Refer to
step 6 for positioning information.
7 Nm
2X
4X
Publicidad
