Publicidad
Idiomas disponibles
Idiomas disponibles
Red Lever & Jaws Assembly
STEP
INSTALL Red Lever:
• Choose access from passenger or
driver side.
• Red Lever should face you when
the LockJaw is attached to Wheel
Tray.
Jaws
Guide Plug
Red Lever
Wheel Tray / Hoop Assembly
INSERT Short Bolt head 8"
1
into slot in Wheel Tray.
Use the Washers and Wing
2
Nut to attach the Hoop
Baseplate onto this bolt.
Slide one SnapAround Bolt
3
into the track at the other
end of the Wheel Tray.
4
Slide the Wheel Straps
onto the Wheel Tray.
STANDARD BIKES:
Place Wheel Straps
need to go between
outside the crossbars.
• Place the GUIDE PLUG into the hole
on one side of the Jaws.
• Insert the Red Lever's bolt threads
through the Guide Plug.
Threaded
Plug
Hoop
Wheel Tray
8"
Short
Bolt
ON SOME
SMALLER
BIKES—
If the Wheel Straps
need to be between
the crossbars, slide
them onto the
WheelTray now.
If not, install them
after the next step.
SMALLER BIKES:
Wheel Straps may
the crossbars.
Insert the THREADED PLUG
into the other hole and squeeze
the Jaws together.
Guide Plug
Push the SnapArounds
SnapAround Bolt
onto crossbar. If you have
1
square bars, see last
page for SnapAround
instructions.
Set Tray/Hoop Assembly onto
2
crossbars. Insert two bolts up
through the SnapArounds
and Baseplate.
Secure with the elongated
Hex Keys.
Insert the remaining bolt through
3
the SnapAround on the other
crossbar.
Tighten all 3 Hex Keys firmly onto
all SnapArounds.
NOTE:
Hoop must rest HORIZONTALLY on
Tray while turning the Hex Keys.
When hoop is raised the Hex Keys
CANNOT BE TURNED.
Turn the Red Lever
clockwise to
engage the
Threaded Plug .
Threaded
Plug
Hex Key
INSTALL
End Caps
Publicidad
