Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Pump Location
Risk of severe injury or death by electrical shock.
•
To reduce risk of electrical shock, disconnect power before working on or around the system. More than one disconnect switch
may be required to de-energize the equipment before servicing.
•
Wire pump system for correct voltage.
•
Be certain that this pump is connected to a circuit equipped with a ground fault circuit interrupter (GFCI) device if required by
code.
•
The pump includes a grounding connector. To reduce risk of electric shock, be certain that it is properly connected to ground.
•
To avoid hazards when installing or servicing, install a double-pole disconnect near the pump installation.
•
Check local electrical and building codes before installation. The installation must be in accordance with their regulations as well
as the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
•
Do not use an extension cord.
•
The pump should only be used with liquids compatible with pump component materials.
Risk of bodily injury, electric shock, or equipment damage.
•
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experi-
ence and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with the unit or in
the immediate vicinity.
•
Equipment can start automatically. Lockout-Tagout before servicing equipment.
•
An inoperative or malfunctioning pump could lead to flooding, resulting in personal injury or property damage.
•
Operation of this equipment requires detailed installation and operation instructions provided in this manual. Read entire manual
before starting installation and operation. End User should receive and retain manual for future use.
•
Keep safety labels clean and in good condition.
•
Keep work area clean, well-lit, and uncluttered.
•
Wear safety glasses while installing or performing maintenance on the pump.
INSTALLATION
Pump Location
• Decide on an area for the pump installation that is suitable based on the enclosure rating of the
electric pump motor. All VersaJet pumps are UL778 approved and will be marked "ACCEPTABLE
FOR OUTDOOR or INDOOR USE."
• Install the pump in a clean, dry, and ventilated location shielded from excessive heat, direct sun, and
precipitation.
• Provide adequate room for future servicing, protection from freezing temperatures, flooding, and
equipment drainage.
• Bolt unit down evenly on a good foundation, preferably concrete, to prevent unnecessary stresses
from pump movement.
• Install as close as possible to water source to minimize suction piping length.
• Seal the well from surface contamination as required by the local authorities with a sanitary well
seal or a pitless adapter.
Piping Instructions
• Properly support suction and discharge piping to avoid strain on the pump.
• Use an opposing pipe wrench on suction and discharge bosses when threading pipes.
• The use of pipe thread sealant is recommended.
• Do not over-tighten piping connections.
2
Publicidad
Tabla de contenido
Solución de problemas
