Rev-A-Shelf 445-VBOSC-8C Instrucciones De Instalación página 2

STEP 1
Place unit on its side and press
orange release levers to disengage
slides and pull slides off the unit.
(See Figure 1).
STEP 2
Using the provided template,
mount the bottom of the slide set
to the floor of the cabinet using (4)
#8 x 3/4" deep thread screws.
Mount the sides of the slide set
to the side (Almond Plate) of the
cabinet using (2) #8 x 1/2"screws
(See Figure 2).
STEP 3
Turn unit onto its side and pull
chain through. Remove chain end
piece and install on cabinet floor
using template. Re-attach the
chain to the end piece end piece
by pushing firmly together (See
Figure 3).
2
Figure 1
SIDE VIEW
BACK OF CABINET
8.64"
(219.4mm)
3.14"
(79.7mm)
Almond Plate
Cabinet floor
Figure 3
Chain
Customer Service: 800-626-1126 | rev-a-shelf.com
Release levers
Figure 2
FRONT OF CABINET
15.96"
(405.5mm)
.75"
(19.1mm)
Back of
BACK OF CABINET
faceframe
.51" (13mm)
Front edge of strap
to back of faceframe
TOP VIEW
FRONT OF CABINET
Use a small flathead
screwdriver to
carefully pry at this
location to separate
end from wire chain
Install this piece on to
the floor of the cabinet
using the template