Tabla de contenido
Publicidad
STEP 7
Measure the cabinet opening
and then measure the door size.
Take the difference of these two
numbers and divide it by 2. This
number is the door overlay or inset
gap (See Figure 9).
STEP 8
If the door is larger than the
opening ADD the door overlay to
the Step 1 dimensions.
If the door is smaller than the
opening SUBTRACT the inset gap
from the Step 1 dimensions.
Mark screw locations to the center
of the thick portion of the door,
pre-drill pilot holes, and attach
door with provided screws
(See Figure 10).
DOOR ADJUSTMENT
INSTRUCTIONS
To add tilt to your door: Tighten
or loosen adjustment screw until
cabinet door is at desired position
(See Figure 11).
Note: Each corner can be
adjusted independently.
To adjust your cabinet door side
to side use a 3/8" nut driver,
you will want to use the lock nut
adjustment (See Figure 12).
Note: All lock nuts must be loose
in order for the door to move
completely left or right.
4
FIG. 9
Cabinet
opening
Difference ÷ 2
(overlay or inset)
FIG. 10
Figure 11
Customer Service: 800-626-1126 | rev-a-shelf.com
Door size
Difference
Mark screw
locations
Figure 12
Publicidad
Tabla de contenido
