Operating The Locomotive - marklin 29199 Manual De Instrucciones

• Inequality of battery types, or new and used
batteries may not be used together.
• Batteries with the correct polarity insert.
• Contacts should not be shorted.
• Batteries do not belong in the garbage!
• Every user in the European Union is legally
responsible for disposing of batteries at a coll-
ection point in his community or at the dealer.
The batteries are then passed on for environ-
mentally friendly processing.
• Batteries containing dangerous materials are
identified by these marks and chemical symbols
(Cd = cadmium,
Hg = mercury, Pb = lead).
Please keep these instructions. They contain
important information.
Put the cover for the battery holder back in
place and screw it down.
7. Operating
7.1 Selecting an address:
(See Section 8 for the appropriate address for
your locomotive.)
Switch Address
• 78
• • 72
• • • 60
• • • • 24
14
Correct address selected? (See section 8).
When operating the IR Control, always line it up
with the lens in the direction of the Base Station.
Press the desired button.
Controlling
Functions
1 – 4 *
2
1
+
0
Braking
-
Emergency
STOP
Stop
* if the locomotive is designed for this
If no other commands are sent within 3 minutes of
the last command, the base station shuts off the
voltage in the track for safety reasons.
If the IR Control is activated again after that, the
base station will turn itself on automatically.
If a short circuit occurs, the Base Station will
shut off and will turn itself on again after the
short circuit has been corrected.
7.2 Changing an Address:
If you have 2 locomotives with the same address,
you can change the address for one locomotive
as follows:
Unplug the transformer. Set the address switches
to the desired address. Press the button „Change
Direction" Hold this button pressed down while
the lens on the IR Control is pointed at shows to
the receiver, and plug the transformer back into
the wall outlet.
Release the button as soon the light comes on.
The programming procedure is displayed when
the light comes on or blinks. As soon as the light
goes out, the programming is turned off. The loco-
motive can now be run with the new address.
Turning on the
light
3
4
+
Accelerating
0
-
Changing
direction /
Train stop