Installing Flat Panel Screen To Wall Plate - PEERLESS Paramount PT660 Manual De Instrucciones

Mounting and Removing Flat Panel Screen
WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount. Tighten screws to 40 in. • lb
(4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen from
the bottom.
3 Tension Adjustment of Ratchet Handle:
tension in tilt brackets (BB & CC) by rotating ratchet
handle. NOTE: If obstruction prevents ratchet handle
from rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Mounting Screen: Ratchet handle must be in the up
or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly hook tilt
brackets (BB & CC) onto wall plate (AA) and swing
screen down as shown in fig. 3.1. Tilt bracket hooks
must fully engage wall plate as shown in detail 1.
Using a phillips screw driver, turn safety screws on tilt
brackets (BB & CC) clockwise till screw tip securely
contacts wall plate as shown in cross section.
Screen Adjustment: Screen can be adjusted
horizontally by loosening safety screws on tilt
brackets (BB & CC) three full turns with a phillips
screw driver. Adjust screen as shown in figure 3.2.
Tighten safety screws on tilt brackets till screw tip
securely contacts wall plate as shown in cross
section.
Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from mount,
and lift screen off of mount.
Adjusting the Tilt Angle of the Flat
Panel Screen
4
For preset tilt angles use
angle use ratchet handle.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to find tilt position hole and tilt screen to
align holes. Tighten IncreLok™ tilt locking screws on
both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to step
3 for tension adjustment of handle).
top or bottom of screen to adjust tilt as shown in figure
4.1. The tilt can be adjusted to a maximum of 15°
forward or 5° backward.
Visit Peerless website at www.peerlessmounts.com
Adjust
Increlok™ and for custom tilt
10° or 15°. Use
Push or pull from
8 of 24
AA
DETAIL 1
AA
SAFETY
SCREW
CROSS SECTION
IncreLok™
TILT LOCKING
SCREW
TILT
POSITION
HOLES
DETAIL 2
ISSUED: 10-31-07 SHEET #: 202-9272-2 04-30-28
For customer care call 1-800-729-0307 or 708-865-8870
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB &
CC
RATCHET
HANDLE
BB &
CC
fig 3.1
fig 3.2
LOCATOR
HOLE
RATCHET
HANDLE
fig 4.1
© 2007, Peerless Industries, Inc. All rights reserved.