Disposal And Recycling; Ordering Spare Parts And Accessories - EINHELL TE-BD 750 E Manual De Instrucciones Original

Taladro de banco
Ocultar thumbs Ver también para TE-BD 750 E:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8.2.1 Changing the V-belt (Figs. 31-32)
The V-belt of the pillar drill is a wear part and
should be replaced when worn. Proceed as fol-
lows:
Run the machine run in idle mode while slow-
ly setting the speed adjustor lever (15) to the
minimum speed.
Switch the machine off, then pull the power
plug.
Set the speed adjustor lever (15) to the maxi-
mum speed setting to slacken the V-belt.
Undo the screw (37) to open the V-belt cover
(7).
Pry the V-belt (39) off of the drive pulley (38)
by pulling up the belt on one side and slowly
turning the pulley (38). The drive pulley (38)
comprises two disks that are pressed to-
gether via a spring. If the V-belt (39) does not
exhibit enough play to remove it, gently press
the bottom half of the drive pulley (38) down
to slacken the V-belt (39).
Fit one end of the new V-belt (39) to the vari-
able pulley (40). Fit the other end to the drive
pulley (38) by first sliding it into the groove on
one side of the pulley (38) , then prying the V-
belt (39) across the pulley into the groove on
the other side.
Close the V-belt cover and screw down using
the screw (37).

8.3 Ordering spare parts and accessories

Please provide the following information when
ordering spare parts:
Type of unit
Article number of the unit
ID number of the unit
Spare part number of the required spare part
Tip! For good results we
recommend high-quality ac-
cessories from
www.kwb.eu
welcome@kwb.eu
Anl_SA_TE_BD_750_E_SPK8.indb 28
Anl_SA_TE_BD_750_E_SPK8.indb 28
GB

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
!
- 28 -
27.02.2018 13:46:45
27.02.2018 13:46:45

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido