Stihl HTA 65 Manual De Instrucciones página 22

English
Remove the filler cap.
N
Filling Chain Oil Tank
Take care not to spill chain oil during
refilling and do not overfill the tank –
leave approx. 1/2" (13 mm) air space.
Closing
Handle is in an upright position:
Position filler cap – markings on filler
N
cap and housing must align.
Push the filler cap down as far as it
N
will go.
20
Push the filler cap down and twist it
N
clockwise until it engages.
Then the markings on filler cap and
housing will align.
Flip the handle down.
N
Filler cap is now closed.
If the filler cap will not engage into the
tank housing
The base of the filler cap is rotated in
relation to the upper part.
Look at the black alignment marks
N
on the top of the filler cap.
1
Left: Base of filler cap is rotated to
the closed position – interior
marking (1) is aligned with
the exterior marking.
Right: Base of filler cap is in the cor-
rect position for installation –
interior marking is below the
clip. It does not align with the
exterior marking.
HTA 65, HTA 85