Philips Norelco S9733/90 Manual De Instrucciones página 26

26
English
accessories that have been supplied with your
product.
Cleaning the beard styler attachment
Clean the beard styler attachment after each
use.
1 Pull the comb off the beard styler
attachment.
Note: Grab the comb in the center to pull it
off the beard styler attachment . Do not pull
at the sides of the comb.
2 Rinse cut hairs off the cutting unit with
lukewarm water.
3 Rinse cut hairs off the comb.
4 Remove the cutting unit from the beard
styler attachment. By pushing the cutting
unit off the beard styler attachment, you
can remove any hairs that have
accumulated inside the beard styler. You
can also rinse the bottom of the cutting
unit.
5 Rinse cut hairs out of the beard styler
attachment.
6 Carefully shake off excess water and leave
the comb, cutting unit and beard styler
attachment to air-dry before you use them
again.