Reset Button - sanindusa 540637111 Instrucciones De Montaje

//BATTERY REPLACEMENT INSTRUCTIONS
Temporary off function:
This function is ideal to perform any kind of activity in front of the sensor without
operating the system (for example, cleaning).
The flush valve will remain shut for 1 minute when this button is pressed once.
To cancel this function and to return to normal operation press the On/Off
button again or wait 1 minute.

Reset button:

This function restores all the factory settings except for the sensor range. If
required, press the Reset button and without releasing it, press the
(+) button once.
Note: To enter the self adjusting mode, use the ADJ button. To change the sensor
range, use the RANGE button.
When the battery weakens, the red indicator light will blink at constant rate. The battery must be replaced
within two weeks.
1 – Carefully open the battery's box.
2 – Replace the used battery with a new 9V battery (Lithium battery is recommended).
3 – Close the box.
52 53
//