Step 12
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (G) and lay it over your unit.
A perforation in the BACK (G) has been provided for access
å
to the SAFETY STRAP. Punch out the perforation and push
the SAFETY STRAP through the hole.
Make equal margins along all four edges of the BACK (G).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
Peel a FELT DISC from the FELT DISC CARD (1M) and stick
å
it onto the bottom surface of each LEGS (B, C, K, and L).
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
Page 16
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
K
B
424355
Caution
NAIL
(30 used in this step)
L
C
1M
www.sauder.com/service
1N