Black 1-9/16" Flat Head Screw - Sauder 424355 Manual De Instrucciones

Step 13
1
D132
Groove
å
Insert the DRAWER SIDES (D132 and D138)
at an angle into the slot at each end of the
DRAWER FRONT (J).
3
M65
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M65) to the DRAWER
FRONT (J). Tighten one HIDDEN CAM.
www.sauder.com/service
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
J D138
Maximum
Arrow
210 degrees
Minimum
190 degrees
Hidden part using
recycled material.
Color may vary.
J
VIEW THE T-LOCK BOX VIDEO
2
U n fi
n i s h
s u r
f a c
e
D132
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D983) into the grooves
in the DRAWER SIDES (D132 and D138) and
DRAWER FRONT (J).
4
Start each screw a few turns before
completely tightening any of them.

BLACK 1-9/16" FLAT HEAD SCREW

D175
D132
M65
å
Fasten the DRAWER BACK (D175) to the DRAWER
SIDES (D132 and D138) and DRAWER BRACE (M65).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the other DRAWERS.
424355
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
D983
J
D138
30S
(20 used in this step)
Be sure the
DRAWER
D138
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 17