Caring For Your Iron After Use - Sunbeam Touch & Go 3890 Manual De Usuario

Caring for your iron after use

Turning off your iron
1.
Turn the Steam control and Fabric Select dial
to OFF.
2. Unplug the iron from the power source.
WARNING: AEVERyank the power cord when
unplugging the iron, this can damage the cord.
Storing your iron
1.
If you do not use your iron on a daily basis,
empty the water reservoir after each use for a
longer iron life. To do so, open the water
reservoir cover and turn the iron upside down
to allow water to flow from the fill hole. Shake
the iron gently to remove trapped water drops.
Close the water reservoir cover.
2. Allow the iron to cool
3. Loosely loop the power cord around the cord
wrap and store the iron on its heel rest.
Important: Wrapping the cord around the iron too tightly
can damage the cord.
Tip: When not ironing, always set the Steam
control and the Fabric Select dial to OFE
11