LUND Elite Serie Instrucciones De Instalación página 3

Installation Steps
Rear Flare
13. Remove (3) factory installed plastic fasteners from the driver side rear wheel well using a phillips screwdriver. Needle nose pliers
may be needed to extract the fasteners.
14. Remove (2) factory installed screws from under the fender trim using a T-25 Torx driver. The screws will be re-used to install the
rear flare. Press flare firmly against sheet metal and tighten all screws.
15. Hold flare to vehicle and install (3) 1/4" panel retainers (RV1-P008) into the wheel well holes indicated. Press frmly on the flare
while installing fasteners.
16. Reinstall (2) T-25 Torx screws previously removed from rear flare in Step 14.
17. Completed rear flare installation.
FRONT OF VEHICLE
Rubber Seal
Inner side of
fender flare
Use Rubber Seal here
Do NOT use Rubber Seal here
NOTE: Actual application may vary slightly from illustrations.
Factory Screw
Retainers
Page 3 of 4
Factory Screw