Installation Steps - LUND Elite Serie Instrucciones De Instalación

Preparation Before Painting / Installation
For RX Style Only (SKIP if you have SX or EX style)
Install the rivet screws and nuts to each of the rivet holes on the flare. Our rivets are designed to screw on to the fender flares only, and they shouldn't be touching the
vehicle body at all. Using hand tools, tighten nuts until fastener is snug. DO NOT OVERTIGHTEN as this may damage the fender flare.
Installation of the Rubber Seal
Before you start cutting any rubber seal, please study the diagram. Do not use the rubber seal in any other areas other than indicated; otherwise you will end up with
a shortage of rubber seal on your last flare. Start the installation of the rubber seal as indicated in the diagram. Then cut the rubber seal with a razor. Follow the same
instruction for the remaining flares.
*Each roll of the rubber seal provided is long enough to complete the 4 fender flares and with extra to spare, however we are not responsible for the improper use of
the rubber seal. Contact Lund International to purchase additional rolls of rubber seal.

Installation Steps

Front Flare
1. Remove (3) factory installed plastic fasteners from the driver side front wheel well using a phillips screwdriver. Needle nose pliers may be needed
to extract the fasteners.
2. Remove (1) factory installed screw from the rear of the fender trim using a T-25 Torx driver.
3. Pull back the fender liner near the front of the fender and locate the turn signal assembly and wiring. Remove and keep (8) factory installed
screws. The remaining screws will be re-used to install the front flare.
4. Squeeze the lower tab on the back of the turn signal assembly and remove from the truck. Carefully turn the wiring harness counter-clockwise and
separate the bulb/wiring harness from the turn signal assembly. Press flare firmly against sheet metal and tighten all screws.
5. Install the turn signal assembly into the front driver side flare.
6. While holding the flare up into place, mark the location of the front hole on the fender liner using a grease pencil.
7. Install (1) black mylar tab around the edge of the fender trim aligned with the grease pencil marking. (See detail S-Clip Installation)
8. Install (1) "S" spring clip over the black mylar tab, centered with the grease pencil marking.
9. Reconnect the turn signal wiring connector and set the flare in place. Hold flare to vehicle and install (3) 1/4" panel retainers (RV1-P008) into the
wheel well holes indicated. Press frmly on the flare while installing fasteners.
10. Reinstall (1) T-25 Torx screw previously removed from rear of the flare in Step 2.
11. Install (1) truss screw through the front hole in the flare into the "S" spring clip using a #2 phillips screwdriver.
12. Completed front flare installation.
FRONT OF VEHICLE
Rubber Seal
Inner side of
fender flare
Use Rubber Seal here
Do NOT use Rubber Seal here
NOTE: Actual application may vary slightly from illustrations.
Black Mylar
Tab
S-Clip
Screw
Retainers
Page 2 of 4
Factory Screw