Publicidad
6
TRIM THE UNDERSIDE OF THE WEATHER-STRIPPING.
WARNING: Do not trim the topside of the weather
stripping! In this step you most cut away the underside
portion of the weather-stripping as directed below.
Use the marks you made on
the topside of the weather-
stripping in step 5 as a guide
and cut away the underside of
the weather-stripping as shown.
7
INSTALL THE CENTER PUNCH.
Use the pointed end of the
center punch to break the
factory applied sealing-tape
to reveal the hole beneath the
sealing-tape that you identified
and marked in step 3.
8
MARK THE WEATHER-STRIPPING WITH THE CENTER PUNCH.
CAUTION: Do not
damage your vehicle
with the mallet.
•
Carefully align and reinstall the
weather-stripping once again.
•
Use a rubber mallet to
carefully hit the center
punch beneath the weather-
stripping.
•
Verify that a mark has been
made to the underside of the
weather-stripping.
•
Remove the weather-stripping
from the vehicle.
Instruction #1036057B - Page 4 of 11
With the pointed end
of the center punch
facing upward, screw
the center punch
into the hole until
the point is slightly
higher than the roof
of the vehicle.
TIP: If threading
the center punch
is difficult, clean
out the threads
by threading one
of the bolts from
this kit in and out a
couple of times.
underside
dessous
lado inferior
1
TIP: use a wooden
dowel or wood block
to help ensure that
you do not damage
your vehicle.
2X
2X
2X
Publicidad
