Publicidad
15
ADJUST LANDING PAD POSITIONS THEN TIGHTEN THEM DOWN.
INSTALL
16
COVERS WHEN
RACK IS NOT
ATTACHED.
Using the covers will
help keep the bases
free of debris.
4X
Instruction #1036057B - Page 6 of 11
17
READ THESE WARNINGS!
•
Make sure your SkyLine or Control
Towers, with bars installed, seat
completely with the Landing Pad. If they
do not seat properly, repeat step 15.
•
Be sure all the hardware is secured
according to instructions. Failure to
perform safety checks before driving
away can result in property damage,
personal injury, or death.
•
Attachment hardware can loosen over
time. Check and tighten, if necessary,
before each use.
•
The Landing Pad top must remain
installed at all times to assist in keeping
the weather-stripping in position.
• Using your tower instructions as a reference,
carefully place an assembled crossbar with
towers onto the Landing Pads.
• Align the position of the Landing Pads to allow
your SkyLine or Control Towers to fully close.
• Center the crossbar and fully torque your
SkyLine or Control towers to the crossbars
according to the tower instructions.
• Open one SkyLine or Control Tower cover
and lift it up while the opposite tower is still
engaged.
• While holding the SkyLine or Control Tower
above the Landing Pad fully tighten the
Landing Pad with the long handle of wrench as
shown to 1.5 Nm.
• Repeat the process again for the other Landing
Pads to ensure they have not changed position.
• Re-insert the SkyLine or Control Tower into the
Landing Pad, fully tighten the tower (refer to
tower instructions) and close the cover.
If you are installing Yakima LockNLoad
platform ensure your left and right landing
pads are installed parallel to one another
MAXIMUM WEIGHT LIMIT
FOR YOUR VEHICLE.
To review your vehicle's specific
weight limit and load limitations for
accessories, visit yakimatech.com.
For additional product support ,
visit yakima.com/support or
contact us directly at (888)925-4621
Monday through Friday, 7:00 AM
to 4:00 PM, PST.
Remove your YAKIMA rack and
accessories before entering
automatic car washes.
1.5 Nm
4X
DO NOT EXCEED
Publicidad
