ELICA LIB0092355C Montaje Y Modo De Empleo página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
Operation anomalies
The hood does not work
Make sure that:
There is no current blackout
A speed has been effectively selected.
The red reset button located above the filters inside the
hood is pressed.
The hood has low efficiency
Make sure that:
The motor speed selected is sufficient for the quantity of
fumes present
The charcoal filter is not worn out.
Maintenance
Cleaning
Clean using ONLY the cloth dampened with neutral liquid
detergent.
DO
NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter
Traps cooking grease particles.
The grease filter must be cleaned once a month using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
Replacing lamps
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are
cooled down.
Replace the old light bulb with the one of the same type as
specified in the feature label or near the light lamp on the
hood.
To replace the lamps in the square shaped spotlights press
the frame of the spotlight, opposite the symbol "PUSH", then
change the bulb and close the spotlight by pressing again on
the frame to hook it.
Replace with a new 12 Volt, 20 Watt (Maximum) halogen light
made for a G-4 base SUITABLE FOR USE IN OPEN
LUMINAIRES. Follow package directions and do not touch
new light with bare hands.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
CLEAN
WITH
TOOLS
OR
12

Publicidad

Tabla de contenido
loading

Tabla de contenido