Ryobi P620 Manual De Utilización página 8

EN
FR DE ES IT NL
WARNING
Beware of any hazards presented by the material being
sprayed and consult the markings on the container
or the informatin supplied by the manufacturer of the
material to be sprayed, including requirements for the
use of personal protective equipment.
WARNING
Do not spray any material where the hazard is not
known.
MAINTENANCE
WARNING
When servicing, use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
WARNING
Always wear eye protection with side shields. Failure to
WARNING
petroleumbased products, penetrating oils, etc., come
in contact with plastic parts. Chemicals can damage,
weaken or destroy plastic which may result in serious
Do not abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
in a hazardous condition leading to possible serious
CLEANING THE SPRAYER FOR STORAGE
PT DA SV FI NO RU
English
PL CS HU RO LV LT
store the sprayer, a thorough cleaning and lubrication is
recommended.
Remove the battery pack from the sprayer.
Remove the paint container.
If you haven't already done so, return any unused
paint or stain to its original container.
Fill the paint container with lukewarm water (following
the use of water based products) or Paint Thinner
(following the use of oil-based products).
Reinstall the paint container.
Install the battery pack in the sprayer.
Spray the solution onto a piece of cardboard or other
scrap material. Continue spraying until all the solution
is used.
Remove the battery pack from the sprayer.
Remove the paint container.
Remove the suction tube and filter.
Remove the installed spray tip by turning it
counterclockwise.
Remove the atomizer valve assembly.
Remove the locking nut by turning it counterclockwise.
off the sprayer
Pull the piston and spring off the pump housing.
Using the cleaning brush provided and the solution
determined by the last type of paint or stain sprayed,
clean all of the above parts thoroughly.
NOTE: Make sure to scrub thoroughly inside the pump
housing opening so that no paint or stain material is
left behind.
To reassemble:
Place a line of lubricant on the piston.
Slide the spring back onto the piston.
Insert the piston and spring assembly inside the back
of the pump housing.
the sprayer.
Replace the locking nut on the motor housing by
pushing in while rotating clockwise to secure.
Insert the atomizer valve assembly into the pump
housing front opening.
Replace the spray tip and rotate clockwise to secure.
Reinstall the suction tube and filter.
Reinstall the paint container.
The sprayer is now ready to be stored.
4
ET HR SL SK BG UK TR EL