GE Druck DPI612 Guia De Inicio Rapido página 8

Safety and Quick Start Guide
2. EXTERNAL PRESSURE CONNECTION
Use an applicable method to seal the external pressure connections, and then
tighten to the applicable torque.
Maximum torque:
Attach the pressure adaptor to the DPI612 and tighten to finger tight.
3. DPI612 PRE-CALIBRATOR – START OPERATIONS
3.1 Install the rechargeable battery
1. Remove the battery cover by unscrewing the retaining screw and lifting the
cover upwards.
2. Insert the CC3800GE rechargeable battery into the compartment as shown
in Figure 4.
3. Refit the battery cover by locating the lugs of the cover (A) at an angle into
the slots and close the compartment as shown in Figure 4.
4. Refit the battery cover retaining screw.
Page 8 of 20
ISO 228/1, 1/8 NPT: 35 Nm (26 lbf.ft)
ISO 228/1, G1/8: 25 Nm (18.4 lbf.ft)
Figure 4
Druck DPI612
[EN] English – 109M0089