Pre-Installation - ETI Solid State Lighting 54292141 Guía De Uso Y Cuidado

Pre-Installation

Two Lamp Fixture
Model # 54292141
Suitable for damp or dry locations when used with UL Listed Type IC or Non-IC, recess mounted or surface
mounted luminaires and suitable for use in totally enclosed luminaires.
Risk of re or electric shock: To prevent wiring damage or abrasion, protect wiring from exposed edges of sheet
metal or other sharp objects that may be present in the xture.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this
device may not cause harmful interference, and 2) this device must accept any interference received, including
interference that may cause undesired operation.
To avoid potential re or shock hazard, do not use this retro t kit in luminaires employing shunted bi-pin lamp
holders. Note: Shunted lamp holders are found only in uorescent luminaires with Instant-Start ballasts. Instant-start
ballasts can be identi ed by the words "Instant Start" or "I.S." marked on the ballast. For more information, contact
ETi Solid State Lighting at (855) 384-7754 or www.etissl.com.
Installers should not disconnect existing wires from lamp holder terminals to make new connections at lamp holder
terminals. Instead, installers should cut existing lamp holder leads away from the lamp holder and make new
electrical connections to lamp holder lead wires by employing applicable connectors.
Do not make modi cations to or alter xture housing, ballast enclosure or electrical components other than those
required for proper installation.
THIS RETROFIT ASSEMBLY IS AN APPROVED COMPONENT OF A LINEAR FLUORESCENT LUMINAIRE KIT
WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL AUTHORITIES
HAVING JURISDICTION.
Non-shunted uorescent lamp holders within xture shall be rewired to line voltage and will no longer operate the
original uorescent lamp. LAMP HOLDERS MUST BE NON-SHUNTED.
Do not use with dimmers.
THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY LIGHTING (BATTERY TYPE) SYSTEMS FOR
FLUORESCENT LIGHTING PRODUCTS.
571.5
6.9
Unit: mm
Electrical Characteristics (Typical value):
Length x width
Voltage AC (V)
Current AC (mA)
Power (W)
PFC
Rated Frequency (Hz)
ETi SSL Inc. - The Americas Headquarters
26650 Renaissance PKW, STE 6
Cleveland, OH 44128
Minimum luminaire dimensions:
Length x Width x Height
Three Lamp Fixture
24" x 24" x 4.25"
+1
-2
22.5˝ x 1.625 (54292141)
120-277
170
15
>0.9
50/60
Model # 54293141
Electrical Characteristics (Typical value):
Length x width
Voltage AC (V)
Current AC (mA)
Power (W)
PFC
Rated Frequency (Hz)
Please contact 1-855-384-7754 for further assistance.
3
Minimum luminaire dimensions:
Length x Width x Height
Two Lamp Fixture
24" x 24" x 4.25"
571.0
22.5˝ x 6˝ (54293141)
120-277
170
15
>0.9
50/60
www.etissl.com