Publicidad
Idiomas disponibles
Idiomas disponibles
Cartridge Installation
1
A.
4
5
3
2
1
Turn off water supplies. Remove
cover (1), bonnet nut (2) and test cap (3)
from the body. If this is not a thin wall
mounting, the entire plasterguard (4)
may be removed. If screen (5) is in place,
remove before installing cartridge.
Back to back Installation
Normal Installation (changes not required)
Reverse
Installation
Cold
Hot
For back to back or reverse installations
(hot on right and cold on left) insert the
cartridge with the "hot side" on the right.
If you are not making a reverse or back
to back installation skip this step and
continue with step 1C.
91342 Rev. B
T60P Series Installation
B.
3
2
4
1
Rotate the cartridge (1) so the words
"hot side" (2) appear on the left. Insert
cartridge into valve body as shown. Make
sure the cartridge tubes and O-rings (3) are
properly seated in holes at the base of the
body. Ensure the keys on the body are fully
engaged with the slots in the body (4).
C.
1
Slide bonnet nut (1) over the cartridge
and thread onto the body. Hand tighten
securely.
3
T60P Series Installation
Showerhead and Tub Spout Installation
2
(For Tub Spout installation refer to the installation guide provided with your tub spout)
FOR SHOWERHEAD INSTALLATION:
Connect top outlet (1) to shower arm (2) with
4
proper fi ttings. To prevent damage to fi nish
on shower arm, insert wall end of shower arm
into shower fl ange (3) before screwing arm
into riser connection. Thread showerhead (4)
onto shower arm. Apply plumber tape to pipe
threads on both ends. Do not overtighten
showerhead.
1
3
3
2
4
FOR RSVP
®
(RP48040), SOTRIA
(RP75722) AND VIRAGE
SHOWER ARM INSTALLATION:
Install a 1/2" threaded pipe nipple to extend
beyond the fi nished wall 3/8" to 1/2". Apply
plumber tape to thread on pipe nipple and screw
brass adapter (1) securely onto nipple. Apply
plumber tape to outlet end of shower arm and
screw showerhead (2) onto the shower arm (3),
using provided wrench (4) to tighten securely.
Check position of set screw on top of shower arm
(3) making sure it is not sticking through to the
inside opening where it could interfere with the
assembly. Slide shower arm and head assembly
over the adapter and tighten set screw against the
adapter.
4
1
4
2
®
®
(RP62603)
91342 Rev. B
Publicidad
