Manual Code Search And Entry - RCA RCR450C Manual Del Usuario

Manual Code Search and Entry

If your component's brand isn't listed in the Code Lists,
or if you have tried all of the codes for your brand and
the remote does not operate your component, try the
Manual Code Search . This Code Search method cycles
through all of the codes in the Code Lists in the event
that your component's code is listed under another brand .
The Manual Code Search method may take a long time
because the remote searches through all of the codes in
its memory for the code that operates your component .
Therefore, if your brand is listed in the Code Lists, first
try the Direct Code Entry method described on page 4 .
CR450_NA_IB_02.indd 5
4 . While holding down the component
key, consult the Code Lists for the
four-digit code that corresponds to
your component's brand and use the
number keys (0-9) on the keypad to
enter it . While you are pressing the
numbers, the LED indicator light
turns off .
LED
5 . After the fourth number is entered,
the LED indicator light turns on . At
this time, release the component key .
If the LED indicator light turns off,
you have entered a valid code and
LED
have followed the correct procedure
for Direct Code Entry .
If you enter a code number that
is not in the Code Lists or you do
not follow all of the steps for Direct
Code Entry, the LED indicator
light blinks four times when the
component key is released . This is an
indication that a programming error
has occurred . In that case, repeat the
Direct Code Entry process from step
3 and try the next code listed .
of each key, be sure to keep the
remote pointed at the IR sensor of
the component you are currently
programming the remote to control .
6 . To confirm that the component
key is programmed with the
correct code for maximum
functionality, test the component .
Attempt to control a variety of the
component's functions with the
remote . If some of the features of
your components do not work,
try programming the remote with
a different code in the list until
you find the code that allows the
remote to control the majority
of your component's functions .
Different codes can provide
different levels of functionality .
Throughout the programming
!
TIP:

1/30/07 1:01:28 PM