Programming The Remote; Programming Methods; Direct Code Entry - RCA RCR450C Manual Del Usuario

Programming the Remote

Your universal remote can operate a variety of brands
of components . In order for your universal remote to
control your components, you need to program the
remote with the codes that match the components (See
Code Lists enclosed) . These codes enable the remote
to communicate with your components . Each brand
and each component has its own "language," and, by
programming the correct codes into your remote, you
tell the remote to "speak the same language" as your
components .
There are two methods you can use to program your
remote control to operate your components: Direct
Code Entry and Manual Code Search and Entry . Most
components can be programmed in one of these ways .
Try them in the order listed .
In order to control combo TV/VCR or TV/DVD units,
you must program both the TV key and the VCR or
DVD key . Once programmed successfully, the TV key
controls the TV functions on your unit, and the VCR or
DVD key controls the VCR or DVD functions . There is
a specific section in the Code Lists for combo units . The
codes in this section should be tried first, using Direct
Code Entry on the TV and VCR or DVD keys . If this is
unsuccessful, follow the normal programming methods
for both the TV and the VCR or DVD keys .

Programming Methods

Direct Code Entry

To program your universal remote to control your
components using the Direct Code Entry Method,
follow the steps below .

CR450_NA_IB_02.indd 4
1 . Manually turn on the component
2 . Locate the enclosed Code Lists .
3 . Press and hold the component
LED
you want the remote to control
(TV, VCR, DVD, satellite receiver
or cable box) .
Find the list for the component
you wish to program . Find your
component's brand . You will
see a listing of four-digit codes
for each brand . If your brand
isn't listed, use the Manual Code
Search method to program the
remote control . (Refer to page 6 for
Manual Code Search method . )
key (TV, VCR, DVD, SAT·CBL)
you wish to program . The LED
indicator light turns on and remains
on . If you release the component
key any time during the Direct
Code Entry procedure, the LED
indicator light blinks four times,
and the process is exited .
1/30/07 1:01:27 PM