Testing The Code For Maximum Functionality - RCA RCR450C Manual Del Usuario

Testing the Code for
Maximum Functionality
To confirm that the component key is programmed
with the correct code for maximum functionality, it is
necessary to test the component . If some of the features
of your component do not work, different codes in the
list can be tried until you find the code that allows the
remote to control the majority of your component's
functions . Different codes can provide different levels
of functionality . Follow these steps to test for maximum
functionality, if you have programmed your remote
using the Manual Code Search and Entry Method .
1 . Once the code has been stored (see Manual Code
Search and Entry Method above), use the remote
to attempt to control a variety of the component's
functions . If the code that has been stored controls the
majority of the component's functions, programming
is complete . If the code stored does not give maximum
functionality, you will want to try another code .
2 . In that case, repeat the Manual Code Search and Entry
Method from step 1 . When the component turns off
for the first time, do not press the STOP key, which
would store the code . Instead, with the unit now off,
continue to press the ON·OFF key repeatedly until the
unit turns back on . Once the unit turns back on, you
have found another code that operates the component .
Press the STOP key .
3 . Test the functionality again by attempting to control
a variety of the component's functions . If the code
that has been stored controls the majority of the
component's functions, programming is complete . If
the code stored does not give maximum functionality,
you will want to try another code .
4 . Repeat the Manual Code Search and Entry Method
from step 1 . Each time a code turns the component on
or off, you have found a code that operates the remote
and needs to be tested for maximum functionality .
Continue through the code lists, cycling through the
codes you have already tried, until you find one that
offers maximum functionality .
CR450_NA_IB_02.indd 7
7 . Once you have found the correct
LED
8 . Once you press the STOP key, the
Because there are so many
!
TIP:
codes, you may have to press the
ON·OFF key many times—possibly
up to 200 times .
code, you must save the new
code by pressing and releasing
the STOP key . The LED indicator
light turns off . You must press the
STOP key to save the code or the
correct code will not be stored!
code is stored .

1/30/07 1:01:29 PM