Publicidad
We appreciate the trust you have placed in JBC by purchasing this equipment. It
has been manufactured with the strictest quality standards in order to give you the
best possible service.
Before using this equipment, we recommend you read these instructions carefully.
Air pressure desoldering system
MS 9025 Ref.9025000
Front
aspiration
inlet
Desoldering air filter
Release the block if you want to use the front
aspiration inlet and block the rear inlet using
the same top.
The MS 9025 is a suction pump that needs an
external compressed air circuit. It has a Venturi
vacuum generator that provides exceptional
suction capacity.
You can connect the following stations from the
JBC range: DI 2860, DD 5700, DM 6700.
Posterior
aspiration
inlet
Connection
Technical specifications
- Supply: 24V.
- Power: 10W.
- Weight of complete unit: 1,6 Kgs.
- ESD protected housing.
Typical surface resistance: 10
square.
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- RoHS compliant.
This product should not be thrown in the
garbage.
Changing the pump inlet filter
-
Disconnect the desoldering iron tube and
unscrew the stopper.
-
Take out the 2 paper filters and throw
away those which are soiled.
-
First place the new filters in the top and
afterwards the toric joint. Always use 2 filters.
-
Screw on the stopper and connect up the
tube.
-
Check the airtightness.
Toric joint Ref.0007717
Spare filters Ref.0005966
JBC reserves the right to make technical changes without prior
notification.
2
ENGLISH
5
-10
11
Ohms/
Publicidad
