KALLISTA P22130 Guia De Instalacion página 3

Bonnet
Spout Shank
Spout Gasket
1. Install the Spout
Remove the sleeve cap.
Loosen the seal nut by turning it counterclockwise.
Remove the tee by turning the tee nut counterclockwise.
Remove the shank nut and shank washer.
NOTE: Some faucet designs are supplied with a separate
escutcheon. Keep the loose escutcheon on the spout shank.
Make sure the spout gasket is properly seated in the groove on
the bottom of the spout (or escutcheon).
Slide the spout shank through the mounting hole.
Reinstall the shank washer and shank nut.
Wrench tighten the shank nut.
Reinstall the tee. Wrench tighten the tee nut.
Tighten the tee bottom seal nut.
Reinstall the sleeve cap.
Kallista
Mounting
Surface
Shank Nut
Tee Nut
Tee
Seal Nut
Sleeve Cap
3
Shank Washer
1008410-2-B