Setting Working Temperature; Setting Operation Time; Setting Timeout; Calibrating (Adjusting) The Oven - Selecta DRY-BIG 2002961 Manual De Instrucciones

INSTRUCTION MANUAL
Heater
DISPLAY
On/Off
Operating time
Fig 1. Display:
a. : Heater On / Off
b. : Operation time
c. TIMER : Timeout
d. RUN : Oven running
Temp(ºC)
Opera-
ting
Ambient
Temp.
Timeout Operation time
Fig 2. Timeout and operation time.
J
.P. SELECTA s.a.
CODE 80098 REV E
7.2 Setting working temperature
Oven
a. The «RUN» led must be off (Press «START/STOP»).
On/Off
b. Press
the desired operating temperature.
7.3 Setting operation time
This time begins to run from the moment the oven reaches the operating temperature.
After this time, heater will stop. But ventilation won't stop.
Timeout
It is not necessary to set an operating time. If this time is «0», the oven will run
continuously (This value is set by default).
a. The «RUN» led must be off (Press «START/STOP»).
b. Press
the desired operating time (in hours and tenths of minute).
c. After this time, and after starting, the oven will reach the operating temperature.
At this time, the
7.4 Setting timeout
This time will begin counting from the moment the oven reaches the operating tem-
perature. (See Fig. 2)
After this time, the heater will stop. However, the ventilation won't stop.
It is not necessary to set a timeout. If this time is «0», the oven will run when pressing
«START» (This value is set on default).
a. The «RUN» led must be off (press «START/STOP»).
b. Press
until the display shows the desired operating time (in hours).
c. When starting the oven
t 7.5 Calibrating (adjusting) the oven
DRY-BIG ovens come factory adjusted. However, if there is a deviation seen of the
indicated temperature in the display regarding the measured temperature inside a
reference thermometer, you can adjust the temperature controller.
Initially, try to correct the error by adding an «Offset» to set the temperature. See 7.5.1
For example:
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
May/2017 (It can be modified without notice)
and without releasing, press
and without releasing, press
led will be lit indicating there's a programmed operation time.
and, again,
, «TIMER» led is lit, indicating a timeout before it starts.
The oven's display indicates 100ºC.
Reference thermometer indicates 99ºC.
An offset of 1.0 must be added.
or until the display shows
or until the display shows
and without releasing it, press
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 12
or