Temperature Exterior Sensor Configuration; Date And Time Configuration - Selecta AUTESTER ST DRY PV-II 30 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80206.00 REV C July 2009
CONF/
CONFIGURATION
CONF/LNG/
LANGUAGE
CONF/WTR/ OFF
EXTERNAL WATER
EXIT
CONF/
CONFIGURATION
CONF/LNG/
LANGUAGE
CONF/CLOCK/ OFF
CLOCK
CONF/CLK/DAT
CHANGE DATE
CONF/CLK/DAT
20/02/2007 12:16:12
CONF/CLK/DAT
EXIT
J
.P. SELECTA s.a.

9.7 Temperature exterior sensor configuration.

You must configure this function if you have installed a second sensor, for
liquid sterilisation cycles (see 7).
Beginning from the «CONFIGURATION» menu, push the single button selector
to enter.
The message «LANGUAGE» appears. Turn the button till «EXTERNAL PROBE».
This display shows the external sensor status: On or Off.
By pushing the single button, the external sensor is set On /Off.
Turn the single button till «EXIT» and then push.
Repeat this action to exit till the main display.

9.8 Date and time configuration

Use this menu to update time and date in the autoclave clock.
Beginning from the «CONFIGURATION» menu, push the single button
selector to enter.
The message «LANGUAGE» appears.
Turn the button till «CLOCK»
Push the single button selector, the display will show the message «CHANGE
DATE».
The date and the time will appear in the display.
To modify the day, month and year, select it by turning the single button,
then confirm by pushing it, modify it by turning again and then confirm by
pushing the button once again.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta @jpselecta.es - website: http://www.jpselecta.es
(It can be modified without notice)
Tel 34 937 700 877 Fax 34 937 702 362
Page: 45