Matrix R30 Manual Del Usuario página 7

A Open HARDWARE FOR STEP 3.
3
B Carefully feed the CABLE (4) through the HANDLEBAR
ASSEMBLY (9) and tuck excess wire inside the console masts.
C Attach HANDLEBAR SET (9) to the CONSOLE MASTS (6 & 7)
U30
using 8 BOLTS (B). Torque settings: 23.1 Nm / 17 lb-ft.
U50
D Using the LEAD WIRE (10), carefully feed the WIRES (11)
through the handlebar assembly. Discard the lead wire.
Attach HANDLEBAR (12) to the HANDLEBAR SET (9) using 4
BOLTS (C) and 4 NUTS (D). Torque settings: 9.5 Nm / 7 lb-ft.
Hardware For Step 3
Description Qty
B Bolt 8
C Bolt (pre-installed) 4
D Nut (pre-installed) 4
10
C 11 12 D
B
7
12
MX16_AG_Bikes_ENG_FRE_SPE_r1_1.indd 12-13
A Open HARDWARE FOR STEP 4.
4
B Attach the WATER BOTTLE HOLDER (13) to the
CONSOLE MASTS (6 & 7) using 4 SCREWS (E).
C Attach the CONSOLE BRACKET (14)
U30 to the HANDLEBAR SET (9) using 4
BOLTS (F) and 4 NUTS (D).
U50
Hardware For Step 4
Description Qty
E Screw 4
F Bolt 4
D Nut 4
14
F
9
9
13
4
E
6
7
U50 SHOWN
A Open HARDWARE FOR STEP 5.
5
B Connect the CABLES (4) to the CONSOLE (15) and
carefully tuck them into the CONSOLE BRACKET (14).
C Attach the CONSOLE (15) to the CONSOLE
U30 BRACKET (14) using 4 BOLTS (G).
U50
D
6
A Open HARDWARE FOR STEP 6.
6
B Attach the CONSOLE BACK COVER (17) to
the CONSOLE (15) using 4 SCREWS (F).
U30
U50
Hardware For Step 5 Hardware For Step 6
Description Qty Description
G Bolt 4 F Screw
15 4 14 G
U50 SHOWN
Qty
4
15 17
F
13
3/10/16 2:04 PM