Water Ace AC R106 Manual Del Usuario página 4

3
Outlet Hose
Water OUT
Water IN
NOTE: If you don't get water in
30 seconds or less, refill the hose
and repeat the process.
INLET HOSE GOES IN THE WATER;
OUTLET HOSE STAYS OUT OF THE
WATER. MOTOR MUST STAY DRY
To prime the pump, fill the suction hose with
water, put it back in the water source, dry
your hands, and start the pump.
Make sure all inlet connections are tight (no
air leaks) and the inlet hose is in the water.
Make sure the end of the outlet hose is not
under water. If the outlet is under water, the
pump may not work.
Plug the cord into a 3-wire, 115 volt, 60 Hz,
grounded A.C. outlet.
You should get water in 30 seconds or less. If
not, refill the hose and repeat the process. If
your pump does not prime on the second try,
check the impeller and the inside of the
pump head for wear. Replace as needed.
The motor must have air circulation around it
for proper cooling. This pump will lift water
12'; trying to lift water more than 12' can
cause the motor to run hot. The motor has a
thermal overload which will stop it if it gets
too hot. If the motor stops, allow it to cool
for 30 minutes before trying to start it again.
WA782
Plug in pump to start it.
Inlet Hose
I N
4
UNPLUG THE PUMP
Unplug the pump before all the water is com-
pletely gone.
DO NOT RUN PUMP DRY!
PERFORMANCE
The pump will deliver 350 gallons/1325 liters
per hour with an unrestricted discharge line.
If the discharge line is restricted or raised
and the pressure on the pump outlet port
increases, it will pump less water.
NOTICE: This pump's motor has brushes.
Inspect the brushes frequently; replace them
if they're worn.
4
Unplug