Installation - AEG SWB66001DG Manual Del Usuario

64 www.aeg.com

INSTALLATION

POSITIONING
Adequate air circulation should be around
the appliance, to prevent overheating. To
achieve sufficient ventilation follow the
instructions relevant to installation.
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Climate class
SN
N
ST
T
ELECTRICAL CONNECTION
CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any
INSTALLATION DIMENSIONS (MM) AND VENTILATION
REQUIREMENTS
Ambient
temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
liability should these safety meas-
ures not be observed.
Consult a qualified electrician or service
technician if the grounding instructions
are not completely understood, or if
doubt exists as to whether the appliance
is properly grounded.
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
WARNING!
We recommend that you wait
4 hours before connecting and
installing the appliance to allow
the refrigerant to flow back into
the compressor.
The appliance must be grounded.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not grounded, connect the appliance to
a separate ground in compliance with
current regulation.
Consult a qualified electrician.