Descargar Imprimir esta página

Saivod SBS536DI Manual Del Usuario página 44

Publicidad

Idiomas disponibles

Idiomas disponibles

Correct Use for Your Refrigerator
Warnings
• Don't use mechanical equipment or other methods to accelerate the
defrosting
process
except
manufacturer.
• Don't use any electrical appliances in the food storage compartments
except the model recommended by the manufacture.
• The R600a refrigerant and cyclopentane foaming material used in the
refrigerator are inflammable. All waste and discarded refrigerators shall
be placed away from naked fire and they are not allowed to burn.
New refrigerator is coming
• Remove all packaging material before using the new refrigerator. This
includes the foam base and all adhesive tape holding the refrigerator
accessories inside and outside.
• Clean both the inside and outside of the refrigerator with wet cloth (a
little detergent could be added into the warm water to wash the cloth and
then wipe it again with the clean water);
• Prepare an independent two-pole socket with grounding contact for the
refrigerator and it shall not share a multi-purpose socket with other
electrical appliances;
• Do connect grounding wire! The grounding pole of the socket shall be
provided with a reliable grounding wire.
• Open the refrigerator body and take out the accessory (decorative cover
for bottom beam) and the two screws from the instruction packaging bag;
then install them into the bottom beam as shown by the schematic
diagram on the right.
Door Height Adjustment
If the doors of the appliance are not aligned then the height of them
can be adjusted, if required please follow the below steps.
Note: The maximum height adjustment is 5mm
Rotate the locking nut clockwise (as shown in the diagram below)
with a wrench for 2 full rotations to loosen it. You can now rotate the
adjusting nut(as shown in diagram below) to raise or lower the height
of the door. Once the door is set to your desired position, then tighten
the locking nut by rotating it anti-clockwise.
81
the
means
recommended
by
the
Refrigerators transportation and location
Transportation
Please don't inverted, squeezed, virbration refrigerator. when
moving, the tilt angle can't larger than 45 degree.
When moving, dont cling the door or coping.
Location
Ensure proper air circulation around refrigerator, dont place the unit
near heat source, direct sunlight, moisture or water, avoid rust and
weakening the insulation.
Top space at least 30cm, space on both the sides and back at least
10cm from the wall, So refrigerator door can open or close
convenience and emanate heat.
Adjusting nut
Left
Locking nut
GB
82

Publicidad

loading