Publicidad
Idiomas disponibles
Idiomas disponibles
[Way to replace the filter]
1. The filter installed in this refrigeratory is refined by NSF42, which can
filter the smell, chlorine and so on in running water.
2. The replacement cycle of the filter is about 6 mouths. When
replacement is needed, the indicator on the display board will turn on.
The replacement cycle may be shortened according to operating
environment.
3. With the function of BY-PASS, it can supply water normally without the
filter. If necessary, additional filter can be installed and used out of the
refrigeratory by yourself.
4. During replacement, little water in the connection part may drop out,
a container can be located under it to receive the drops.
5. The filter is installed in the liner of the refrigerator. You can seize the
lower bugle and whirl it leftward to take it out. When it is difficult to take
out, you can detach the lampshade in the refrigerator before detaching
the filter.
6. The assembling is in opposite order. Push it upwards and whirl it
rightward at the same time.
Introduction of Function
See the following figure for keys and display configuration of
man-machine interface (Operation interface subject to material object)
Display Control
Power on the display panel to reach full display after 3s, the start-up
tone rings and the panel displays the systemic memory mode and
temperature settings. This is a lock mode. The factory default memory
93
status of main control board: temperature of refrigerating chamber
and freezing chamber is set to 5 °C and -18°C respectively; there is no
setting for special mode; the ice-maker is off by default. After the
operation of display panel, the status is changed and memorized to
main control board.
In normal cases, display screen enters standby state and then dies out
after display board is locked without operation of door opening and key
operations for 30s.
Where there are key operation, communication failure, sensor failure
and ice-making malfunction when the door is opened, the display
screen will light up and prompt relative information. Numeric area
displays the temperature settings of all chambers; when a
communication failure occurs, the area of freezing temperature gives
a prompt of communication failure; when a sensor failure occurs, the
area of freezing temperature give a prompt of all fault codes in turns
under the lock state; in unlock state, the unlock pattern lights up; in
lock state, the lock pattern lights up. To operate the unlocked keys
under the lock state (except option key of ice water and filter reset),
the lock pattern will flash lights.
Key Operation
FRZ.TEMP.: Freezing temperature key
REF.TEMP.: Refrigerating temperature key
MODE.SEL: Option Key of Function
LOCK/UNLOCK: Lock/Unlock Key
ICE OFF: Ice-maker On/Off Key
DISPENSER: Option Key of Ice Water
1. LOCK/UNLOCK
Hold "LOCK/UNLOCK" key for 2s under the unlock state, the system
enters the lock state; hold "LOCK/ UNLOCK" key for 2s under the lock
state, the system enters the unlock state.
In unlocking, the unlock pattern lights up; in locking, the lock pattern
lights up.
To operate the unlocked keys under the lock state (except option key of
ice water and filter reset), the lock pattern will flash lights.
GB
94
Publicidad
