Kobalt K7343 Manual Del Usuario página 6

Wear ear protection. Exposure to noise can cause hearing loss.
•
Always switch the machine off and wait until it has come to a standstill before placing it
•
down.
Use only sharp cutter bits that are not chipped or cracked. Blunt cutter bits will cause stalling
•
and burn the workpiece.
Never use this router motor with a cutter bit larger than 1-1/4 inch in diameter.
•
Always use cutter bits that are designed for this router. Never use cutter bits which are
•
larger in diameter than the opening, which could cause possible loss of control or create other
hazardous conditions that could cause serious personal injury.
GENERAL SAFETY WARNING FOR BENCH TOOLS
Keep guards in place and in working order.
•
Remove adjusting keys and wrenches. Form a habit of checking to see that keys and
•
adjusting wrenches are removed from the tool before turning it on.
Keep the work area clean. Cluttered areas and benches invite accidents.
•
Don't use in a dangerous environment. Don't use power tools in damp or wet locations or
•
expose them to rain. Keep the work area well lit.
Keep children away. All visitors should be kept a safe distance from the work area.
•
Make workshop childproof with padlocks and master switches, or by removing starter
•
keys.
Don't force tool. It will do the job better and safer at the rate for which it was designed.
•
Use the right tool. Don't force tool or attachment to do a job for which it was not designed.
•
Use proper extension cord. Make sure your extension cord is in good condition. When
•
using an extension cord, be sure to use one heavy enough to carry the current that your
product will draw. An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating. Table 1 shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
6
kobalttools.com