Installing The Router Table Assembly - Kobalt K7343 Manual Del Usuario

INSTALLING THE ROUTER TABLE ASSEMBLY

21. ATTACHING THE LEGS TO THE TABLETOP
a. Place the router table surface assembly on a flat, level
surface, with the underside of the table facing up.
b. Position the legs against the underside of the tabletop
surface as shown.
c. Position one short end of the table so that it extends
beyond the edge of the work surface far enough to
gain access to the four holes in that end of the router
table surface assembly.
d. Align the two outermost holes on the router table
surface assembly with the holes in the leg bracket.
e. Place a small washer onto each of two short pan-head
screws. Insert the short pan-head screws up through
the outer holes in the router table surface assembly
and through the holes in the leg bracket. Place a
small washer, a spring washer, and a small nut on the
threads of each screw then tighten the nuts.
f. Place a small washer onto each of two long pan-
head screws. Insert the long pan-head screws up
through the other two holes on the router table surface
assembly and through a small washer, a spring
washer and a small nut in the leg bracket. Tighten the
screws.
g. Repeat with the other leg.
21a
21b
23
kobalttools.com