PRASTEL EASYKA Manual Del Usuario página 37

EASYKA - EASYBKA
5.1.4 Changing from Bypass Mode to Normal Mode:
To set the Normal/Bypass code refer to
par 14.
1. Insert the code. Mode LED will
flash green.
2. Press the "#" key to confirm the
Mode change. Mode LED will turn
green.
6. Auxiliary Input and Output
The EASYKA auxiliary input and output can be configured in different
combinations, for optimum usability in different applications. (see
par.15).
7. Request to Exit (REX) Button
The REX button must be located inside the premises to be secured
and is used to open the door without the use of a proximity card or PIN
code, it is usually located in a convenient location, e.g. Inside the door
or at a receptionist's desk. The function of the REX button depends on
whether the Lock Strike Relay is programmed for Fail Safe Operation
or Fail Secure Operation.
1. Fail Secure Operation: From the moment the REX button is
pressed, the door will be unlocked until the "Lock Strike Release
Time" has passed. After this time, the door will be locked even if
the REX button has not been released.
2. Fail Safe Operation: From the moment the REX button is
pressed, the door will be unlocked until the REX button is
released, plus the "Lock Strike Release Time". In this case the
"Lock Strike Relay" only begins its count down once the REX
button has been released.
ENGLISH ISEASYKA_07_06.doc
ORANGE
GREEN
GREEN
37