PRASTEL EASYKA Manual Del Usuario página 53

EASYKA - EASYBKA
19.2 Relay Code Assignment using the Code Search Method
1. Enter Programming Mode
2. Press "9" to enter Menu 9: The Mode
LED will turn green.
3. Enter the 3-digit User Slot 000: The
Door LED will flash orange.
4. Enter the 4-digit PIN Code of the
Primary Code belonging to the user
you want to assign a code to: The
Mode LED will flash green.
5. Enter the assignment digit for the
current User Slot:
"1" assigns the Lock Strike Relay
only
"2" assigns the Auxiliary
Relay only
"3" assigns the Lock Strike and Auxiliary Relay
6. If the assignment digit is valid the LED 'Mode' will stop flashing
and the EASYKA is now waiting for another slot number. Press
the "#" key to go to the next slot, press the "#" key for 2 seconds
to return to Normal Mode.
20. Enabling or Disabling the built-in keypad heater
The EASYKA contains a built-in keypad heater. When is enabled the
keypad heater will activate when the
ambient temperature drops to approx. 3
C to 5 C and will remain active until the
keypad temperate rises to approx 5 C to
8 C.
When the heater is enabled
EASYKA is lowest
temperature is -20 C, otherwise is 0°C;
When the built-in keypad heater is active it will require additional power.
ENGLISH ISEASYKA_07_06.doc
GREEN ORANGE
ORANGE
GREEN
Strike
ORANGE
GREEN
GREEN
GREEN
GREEN
the
operating
53
GREEN