PRASTEL EASYKA Manual Del Usuario página 55

EASYKA - EASYBKA
5. You now have 15 seconds to use the default Normal/Secure
Code 3838 in order to return to normal mode, where you may
enter programming mode and enter a new Normal/ Secure Code
23. Return to Factory Default Settings and selection
of code length
Warning:
You must be very careful before using this command! Doing so
will erase the entire memory which includes all User and Special
Codes, and return all codes to their factory defaut settings.
1. Enter Programming Mode
2. Press "0" to enter Menu 0
3. Press the number
corresponding to the desired
length of the code:
0 = 4 digits
5 = 5 digits
6 = 6 digits
8 = free length, from 4 to 8
digits (in this mode, when a
code with less than 8 digits is
input, it must be confirmed by pressing the # key).
Both the LED will flash red
4. Insert the programming code: If the Programming Code is valid,
all memory will be erased, you will hear three beeps and the
controller will return to Normal Mode (If the Programming Code
is invalid you will hear a long beep and the controller will return
to Normal Mode without erasing the memory of the controller).
Note: if the programming code is misplaced, follow the procedure
described in section 21 before restoring factory settings.
.
ENGLISH ISEASYKA_07_06.doc
GREEN
RED
RED
55