Zoeller HPP360 Guia De Inicio Rapido

GARDEN HOSE UTILITY PUMP
MODELS HPP360, HPP12V, 473707
MODEL #HPP360 / 473707
Description
Pump 115V or 12V
Inlet Hose
Puddle Vac
QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR
COMPLETE DETAILS.
3
PRIMING INSTRUCTIONS:
IMPORTANT: Pump MUST be primed before it is turned on.
Inlet
Outlet
Outlet
To prime pump, fill the pump cavity through inlet to wet impeller.
Connect supplied 6 ft. inlet hose and submerge below surface of
water. Turn on pump.
1
PUMP LOCATION:
Outlet
MODEL #HPP12V
Quantity
1
1
1
Pump should be located so that the water source is within reach
of supplied 6 ft. inlet hose.
4
TURNING PUMP ON:
Models HPP360 and
473707: Plug the cord
into a 3-wire, 115 volt, 60
Hz grounded A/C outlet
protected by a ground-
fault circuit interruptor.
Inlet
Model HPP12V:
Attach red
battery clip to
positive terminal
and black battery
clip to negative
terminal of a fully
charged battery.
Inlet
3 ft. Max.
Vertical
Water Source
Black Battery
Clip
Outlet Hose
Discharge
Water
Red
Battery
Clip
Positive
Terminal
Water
Source
2
ATTACHING HOSES:
Outlet Hose
Install inlet hose on the inlet side of pump.
Attach 5/8 in. outlet hose (not included) on the outlet side of pump.
NOTE: Outlet hose should be as short as possible and no longer
than 25 ft.
5
OPERATING
INSTRUCTIONS:
IMPORTANT: For best
results, DO NOT COIL
OR kINk THE HOSES.
Negative
Terminal
This unit is shipped with a Puddle Vac accessory for removing
water from flat surfaces.
Battery
CAUTION: Before water is completely gone, unplug the pump.
DO NOT RUN PUMP DRY!
023912 B