GiBiDi F 12 Rally Manual Del Usuario página 18

18
UK
PADESTRIAN CYCLE PROGRAMMING
After programming the run, pause and phase shift times, the PEDESTRIAN CYCLE times can be programmed.
In the case of the control unit with built-in radio (code AS04260), first self-learn the second key of the radio
control and then set DIP5 to ON to enable the relevant function.
START PROGRAMMING WITH THE GATE COMPLETELY CLOSED.
IMPORTANT: Always start this phase with the gate completely closed.
Set DIP1 to ON to start programming: the LEDs DL1 and DL2 come on and the control unit will emit some
BEEPS to indicate the number of cycles set for maintenance (see dedicated paragraph).
• Press Pedestrian Start (second TX channel or contact on terminals 1-3)
WING 1 STARTS OPENING
• When wing 1 arrives in the desired position again press Pedestrian Start (or wait for the wing to stop against
the relevant mechanical opening stop).
WING 1 STOPS
• The control unit starts counting the pause time (max. 90 seconds)
• When the desired pause time has elapsed, press Pedestrian Start
WING 1 STARTS CLOSING
• Wait for the motion to stop when the mechanical closing stop has been reached and set DIP1 to OFF.
FAST RECLOSING
This function allows reducing the pause time to 3 sec. from activation and subsequent freeing of the photocells.
How to enable this function: during time programming, when the gate is in opening pause, intercept the
photocells for at least five seconds.
At this point, a BEEP will signal that the function has been enabled (in fact, it becomes operational only at the
end of the programming phase).
Continue with the programming phase starting from the pause time delay.
To disable this function: repeat the programming procedure.
In this condition the real pause time is calculated from the moment in which the photocells
are freed.
OPERATION WITH ONLY ONE MOTOR
The control unit can be made to operate with only one motor using the MOTOR 1 output (terminals 16 and 17).
Proceed as follows:
• Adjust trimmer RV2 to the maximum (turned clockwise)
• Short-circuit terminals 18 and 19 (motor 2)
• Execute time programming (N.B. after the desired pause two Start commands must be given)
• At the end of the programming phase, remove the jumper between pin 18 and 19 (!).
F12 RALLY